USB Connection Failure with DCS Rossini Player after Sense 3.3 Update

[qqboy]

I am writing to report a critical issue encountered after updating my Zenith NG to the latest firmware version 3.3.

Issue Description:

• When attempting to connect the player via USB to my DCS Rossini DAC/Player, the system persistently displays a "Player Connecting" status message.
• The connection never completes, rendering USB audio playback entirely non-functional.
• This issue did not occur prior to the firmware 3.3 update.

 

[Stephen Healy]

Have you tried a complete power cycle of both source and DAC, USB disconnect and reconnect? If so and still no improvement then let me know.

 

[qqboy]

Yes, I performed a full power cycle (both devices off >5 mins) and reconnected USB cables. Issue remains:

• Innuos Standalone Mode: Stuck on "PLAYER CONNECTING".
• Roon Bridge Mode: USB works perfectly.

 

[DanCollier]

Good morning,

Please go to advanced settings and clear the queue cache. Does this resolve your issue?

 

[qqboy]

Followed your advice: Cleared queue cache in advanced settings. No improvement – still stuck on "PLAYER CONNECTING" in standalone mode.

UPNP Streamer is detected but cannot be selected as a player

Therefore, I am currently limited to using Roon Bridge mode for music playback and cannot use the Sense player.

 

[DanCollier]

Followed your advice: Cleared queue cache in advanced settings. No improvement – still stuck on "PLAYER CONNECTING" in standalone mode.

UPNP Streamer is detected but cannot be selected as a player

Therefore, I am currently limited to using Roon Bridge mode for music playback and cannot use the Sense player.

When you're in standalone mode, are you able to access LMS?
Add ":9000/default/settings/index.html" after the ip address for your system in a web browser. Show me what you get.

 

[qqboy]

The LMS console homepage is functioning normally. I’ve captured three screenshots for your reference:

• Image 1: LMS Console BASIC Settings page.
• Image 2: LMS Console Player Management page.
• Image 3: Current status in the SENSE app.

Screenshots are attached below.

 

[DanCollier]

Please get in touch with me in support as I will need to perform a remote session to look at your issue, you can send the support request directly from Sense in the settings menu by selecting "Contact Support".

It appears to be an LMS issue, it could be that the there was some network stability issues during the update process. If you're using network extenders/repeaters (powerline etc) these are typically fairly prone to network glitches and instability.

 

[qqboy]

Okay, thank you. My Zenith NG is currently connected to a sub-router extender. I have already submitted a support request via the Sense app.

 

[DanCollier]

Okay, thank you. My Zenith NG is currently connected to a sub-router extender. I have already submitted a support request via the Sense app.

I sent you a link for a remote session 20 minutes ago. Please check your email and respond there from now on please.