Recent content by Greg Linton

Update. Using the 12 volt voltage converter worked. I however wasn’t really pleased with the setup. The battery holder was really cheap and the battery itself would drain after a few hours meaning charging needed to be monitored. I also needed to incorporate an inline or mounted fuse at the...

I actually applied the battery voltage of 19 + volts by mistake. It worked. I did not leave it though.

I might just had a few 3 amp diodes in series to drop the voltage or a small 5 amp converter. Thanks for the feedback.

Thanks all but my original question remains unaddressed. My question was if 18 volts can be supplied to the MK2 instead of 12 volts. I see that the MK3 has a 9 to 24 volt range. Is the MK2 similar? The input power is labeled 12 V.

Many thanks for the quick response. My question was if 18 volts can be supplied to the MK2 instead of 12 volts. I see that the MK3 has a 9 to 24 volt range. Is the MK2 similar? I would like to avoid an 18 to 12 volt converter in the power supply. My PSU will likely be an 18 volt 8.0 Ah CAS...

I have an old Zen Mini Mk2. What is the maximum DC voltage input? Can one use 18vdc instead of 12vdc? Goal is to run a ProJect Pre DS2 (18V) and my Zen Mini MK2 with a dual output 18VDC LSPU.